requirements and specifications document
11Modeling and Simulation: Conceptual Modeling Overview — Contents 1 Introduction 2 Techniques 2.1 Data Flow Modeling 2.2 Entity Relationship Modeling 2.3 …
12Verification and validation — IV V redirects here. For NASA s IV V Facility, see Independent Verification and Validation Facility. Verification and validation is the process of checking that a product, service, or system meets specifications and that it fulfills its intended… …
13Verification and Validation — Verification Validation is the process of checking that a product, service, or system meets specifications and that it fulfils its intended purpose. These are critical components of a quality management system such as ISO… …
14System requirements (Spacecraft system) — System requirements in Spacecraft systems are the specific system requirements needed to design and operate a spacecraft or a Spacecraft subsystem. Overview [ V Model of the general Systems Development Life Cycle.… …
15Geometric dimensioning and tolerancing — (GD T) is a system for defining and communicating engineering tolerances. It uses a symbolic language on engineering drawings and computer generated three dimensional solid models for explicitly describing nominal geometry and its allowable… …
16Structured Systems Analysis and Design Method — (SSADM) is a systems approach to the analysis and design of information systems. SSADM was produced for the CCTA, a UK government office concerned with the use of technology in government, from 1980 onwards. The names Structured Systems Analysis… …
17Federal Specification for Candy and Chocolate Confections — The Federal Specification for Candy and Chocolate Confections is a document, enacted by the Federal Supply Service of the United States in 1979, that defines and outlines requirements for candy and chocolates that the Federal Government may use.… …
18Hazard Analysis and Critical Control Points — (HACCP) is a systematic preventive approach to food safety and pharmaceutical safety that addresses physical, chemical, and biological hazards as a means of prevention rather than finished product inspection. HACCP is used in the food industry to …
19Object-oriented analysis and design — (OOAD) is a software engineering approach that models a system as a group of interacting objects. Each object represents some entity of interest in the system being modeled, and is characterised by its class, its state (data elements), and its… …
20Continuity of Care Document — The Continuity of Care Document (CCD) specification is an XML based markup standard intended to specify the encoding, structure and semantics of a patient summary clinical document for exchange. The CCD specification is a constraint on the HL7… …
