- Standard penetration test
The standard penetration test (SPT) is an in-situ dynamic penetration test designed to provide information on the
geotechnical engineering properties ofsoil . The test procedure is described in theBritish Standard BS 1377-9:1990 andASTM D1586.Procedure
The test uses a thick-walled sample tube, with an outside diameter of 50 mm and an inside diameter of 35 mm, and a length of around 650 mm. This is driven into the ground at the bottom of a
borehole by blows from a slide hammer with a weight of 63.5 kg (140 lb) falling through a distance of 760 mm (30 in). The sample tube is driven 150 mm into the ground and then the number of blows needed for the tube to penetrate each 150 mm (6 in) up to a depth of 450 mm (18 in) is recorded. The sum of the number of blows required for the second and third 6 in. of penetration is termed the "standard penetration resistance" or the "N-value". In cases where 50 blows are insufficient to advance it through a 150 mm (6 in) interval the penetration after 50 blows is recorded. The blow count provides an indication of thedensity of the ground, and it is used in manyempirical geotechnical engineering formulae.Purpose
The main purpose of the test is to provide an indication of the relative density of
granular deposits, such assand s andgravel s from which it is virtually impossible to obtain undisturbed samples. The great merit of the test, and the main reason for its widespread use is that it is simple and inexpensive. The soil strength parameters which can be inferred are approximate, but may give a useful guide in ground conditions where it may not be possible to obtain borehole samples of adequate quality like gravels, sands,silt s,clay containing sand or gravel and weak rock. In conditions where the quality of the undisturbed sample is suspect, e.g. very silty or very sandy clays, or hard clays, it is often advantageous to alternate the sampling with standard penetration tests to check the strength. If the samples are found to be unacceptably disturbed, it may be necessary to use a different method for measuring strength like theplate test . When the test is carried out in granular soils belowgroundwater level, the soil may become loosened. In certain circumstances, it can be useful to continue driving the sampler beyond the distance specified, adding further drilling rods as necessary. Although this is not a standard penetration test, and should not be regarded as such, it may at least give an indication as to whether the deposit is really as loose as the standard test may indicate.The usefulness of SPT results depends on the soil type, with fine-grained sands giving the most useful results, with coarser sands and silty sands giving reasonably useful results, and clays and gravelly soils yielding results which may be very poorly representative of the true soil conditions. Soils in arid areas, such as the
Western United States , may exhibit natural cementation. This condition will often increase the standard penetration value.The SPT is used to provide results for empirical determination of a sand layer's susceptibility to
earthquake liquefaction , based on research performed by Harry Seed,T. Leslie Youd , and others.ee also
*
Cone penetration test
*Geotechnical investigation References
* [http://web.umr.edu/~rogersda/umrcourses/ge441/NOTES%20for%20STANDARD%20PENETRATION%20TEST.pdf University of Missouri - Rolla] Class notes on the SPT.
Wikimedia Foundation. 2010.